Noritake Get Started with GT-CP | GTOMP
Sample Image Menu: Use Sample Program
“GTOMP” is software for designing and programming GT-CP. The following article introduces how to make the sample program work using GTOMP.
GTOMP Sample Image Menu
Display the menu of the image list. Then tap the image to enlarge the photo display.
Write this program with GTOMP and actually run it.
The point is that you can create such a gallery without writing a single line of program code.
Loading samples using GTOMP
Connect GT-CP and open GTOMP. At this time, make sure that the connected port is correct.
Next, prepare sampleimage.gto in sampleimage.zip from the link.
Open “sampleimage.gto” from “File”-> “OPEN” of GTOMP. Then all the images etc. will be prepared.
Writing an image
Next, open “Memory Tool” and write an image file etc. to FROM2(Internal flash memory) of GT-CP from “Write Display”.
Then the memory tool closes.
Writing a program
Click “Build” at the top right of the screen, and click “OK” on the confirmation screen.
(The Code Viewer screen opens)
Click “Mnemonic-> Binary” at the bottom of the screen, and click “OK” on the confirmation screen.
(Source code is converted to binary code)
Then click “Write PMacro” on the left
(The program is written to the module)
Click “Yes” when the completion window is displayed.
(The contents of the sample program are executed on the module)
Since the writing is completed, please check the operation of the module.
The “Terminal” screen will open, but please close it as it will not be used this time.
Learn more about Noritake with the following additional resources:
